Once the principle of booting a filesystem in a file on a DOS partition has been established there are many other things that you can now do.
If it is possible to boot Linux from a file on a DOS harddisk by using a boot floppy then it is obviously also possible to do it using the harddisk itself.
A configuration boot menu can be used to give the option of running
LOADLIN from within the
AUTOEXEC.BAT. This will give a much
faster boot sequence, but is otherwise identical.
LOADLIN is only one option for booting a Linux kernel. There is
LILO that does much the same but without needing DOS.
In this case the DOS format floppy disk can be replaced by an ext2fs format one. Otherwise the details are very similar, with the kernel and the initial ramdisk being files on that disk.
The reason that I chose the
LOADLIN method is that the arguments that
need to be given to
LILO are slightly more complex. Also it is more
obvious to a casual observer what the floppy disk is since it can be read under
I have tried the NTFS method, and have had no problems with it. The NTFS filesystem driver is not a standard kernel option in version 2.0.x, but is available as a patch from http://www.informatik.hu-berlin.de/~loewis/ntfs/. In version 2.2.x the NTFS driver is included as standard in the kernel.
The only changes for the VFAT or NTFS options are in the initial ramdisk, the
/linuxrc needs to mount a file system of type vfat or ntfs rather
I know of no reason why this should not also work on a VFAT partition.
The process of installing Linux on a PC from a standard distribution requires booting from a floppy disk and re-partitioning the disk. This stage could instead be accomplished by a boot floppy that creates an empty loopback device and swap file. This would allow the installation to proceed as normal, but it would install into the loopback device rather than a partition.
This could be used as an alternative to a
UMSDOS installation, it would
be more efficient in disk usage since the minimum allocation unit in the ext2
filesystem is 1kB instead of up to 32kB on a DOS partition. It can also be used
on VFAT and NTFS formatted disks which are otherwise a problem.
This method can also be used to boot a Linux system from a device that is not normally bootable.
Obviously there are many other devices that could be used, NFS root filesystems are already included in the kernel as an option, but the method described here might also be used instead.
Закладки на сайте
Проследить за страницей
Created 1996-2021 by Maxim Chirkov
Добавить, Поддержать, Вебмастеру