> vlan на Fa0 прописать забыли?
> Или маршрутизацией другая железяка занимается?На fa0 нельзя прописать влан. Он изначально в режиме access Этот порт отличается от остальных на 2960Х
Вот
2960X_SW1(config-if)#int fa0
2960X_SW1(config-if)#?
Interface configuration commands:
aaa Authentication, Authorization and Accounting.
arp Set arp type (arpa, probe, snap) or timeout or log
options
auto Configure Automation
autonomic Autonomic Networking
bandwidth Set bandwidth informational parameter
carrier-delay Specify delay for interface transitions
cdp CDP interface subcommands
crypto Encryption/Decryption commands
cts Configure Cisco Trusted Security
dampening Enable event dampening
datalink Interface Datalink commands
default Set a command to its defaults
delay Specify interface throughput delay
description Interface specific description
duplex Configure duplex operation.
exit Exit from interface configuration mode
flow-sampler Attach flow sampler to the interface
flowcontrol Configure flow operation.
help Description of the interactive help system
history Interface history histograms - 60 second, 60 minute and
72 hour
hold-queue Set hold queue depth
ip Interface Internet Protocol config commands
ipv6 IPv6 interface subcommands
keepalive Enable keepalive
link Interface link related commands
lldp LLDP interface subcommands
load-interval Specify interval for load calculation for an interface
location Interface location information
logging Configure logging for interface
loopback Configure internal loopback on an interface
macro Command macro
neighbor interface neighbor configuration mode commands
network-policy Network Policy
nmsp NMSP interface configuration
no Negate a command or set its defaults
ntp Configure NTP
onep Configure onep settings
pagp PAgP interface subcommands
power Power configuration
routing Per-interface routing configuration
service-policy Configure CPL Service Policy
service-routing Service Routing in Interface Mode
shutdown Shutdown the selected interface
small-frame Set rate limit parameters for small frame
snmp Modify SNMP interface parameters
source Get config from another source
spanning-tree Spanning Tree Subsystem
speed Configure speed operation.
standby HSRP interface configuration commands
subscriber Subscriber inactivity timeout value.
timeout Define timeout values for this interface
topology Configure routing topology on the interface
traffic-shape Enable Traffic Shaping on an Interface or Sub-Interface
transmit-interface Assign a transmit interface to a receive-only interface
tx-ring-limit Configure PA level transmit ring limit
vtp Enable VTP on this interface
Как вы его в VLAN загоните? нет тут switchport :(