- Как разобрать vlan-tunnel на router, ilya, 15:23 , 03-Май-06 (1)
- Как разобрать vlan-tunnel на router, sh_, 15:54 , 03-Май-06 (2)
- Как разобрать vlan-tunnel на router, ilya, 16:05 , 03-Май-06 (3)
- Как разобрать vlan-tunnel на router, Boogyman, 16:08 , 03-Май-06 (4)
>R2821(config-subif)#encapsulation dot1Q 60 second-dot1q ? > WORD Second (inner) VLAN IDs e.g. 100,200-300,400,500-600 > any All Inner VLAN IDs not configured on >another subinterface > >>встроенные в саму 2821 скорее всего нет. > >Поясните pls... cisco2821(config-subif)#enc cisco2821(config-subif)#encapsulation d cisco2821(config-subif)#encapsulation dot1Q 520 ? native Make this as native vlan <cr>
cisco2821(config-subif)# ..... наверно IOS не позволяет. У меня: ! version 12.4 ! boot system flash c2800nm-advipservicesk9-mz.124-4.T1.bin !
- Как разобрать vlan-tunnel на router, sh_, 16:30 , 03-Май-06 (5)
- Как разобрать vlan-tunnel на router, Boogyman, 16:38 , 03-Май-06 (6)
>У меня >c2800nm-advipservicesk9-mz.124-3c.bin > >sh ver покажи... cisco2821#sho version Cisco IOS Software, 2800 Software (C2800NM-ADVIPSERVICESK9-M), Version 12.4(4)T1, RELEASE SOFTWARE (fc4) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2005 by Cisco Systems, Inc. Compiled Wed 21-Dec-05 17:42 by ccaiROM: System Bootstrap, Version 12.3(8r)T7, RELEASE SOFTWARE (fc1) ROM: Cisco IOS Software, 2800 Software (C2800NM-IPBASE-M), Version 12.3(8)T5, RELEASE SOFTWARE (fc2) cisco2821 uptime is 5 hours, 54 minutes System returned to ROM by power-on System image file is "flash:c2800nm-advipservicesk9-mz.124-4.T1.bin" This product contains cryptographic features and is subject to United States and local country laws governing import, export, transfer and use. Delivery of Cisco cryptographic products does not imply third-party authority to import, export, distribute or use encryption. Importers, exporters, distributors and users are responsible for compliance with U.S. and local country laws. By using this product you agree to comply with applicable laws and regulations. If you are unable to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at: http://www.cisco.com/wwl/export/crypto/tool/stqrg.html If you require further assistance please contact us by sending email to export@cisco.com. Cisco 2821 (revision 53.51) with 249856K/12288K bytes of memory. Processor board ID FHK0902F3Y4 2 Gigabit Ethernet interfaces 1 Virtual Private Network (VPN) Module DRAM configuration is 64 bits wide with parity enabled. 239K bytes of non-volatile configuration memory. 62592K bytes of ATA CompactFlash (Read/Write) Configuration register is 0x2102 cisco2821#
- Как разобрать vlan-tunnel на router, sh_, 16:58 , 03-Май-06 (7)
- Как разобрать vlan-tunnel на router, Boogyman, 17:02 , 03-Май-06 (8)
>sh run у этого интерфейса покажи... cisco2821#sho run int gigabitEthernet 0/1.2 Building configuration...
Current configuration : 142 bytes ! interface GigabitEthernet0/1.2 encapsulation dot1Q 520 ip address 10.10.7.254 255.255.255.0 no snmp trap link-status no cdp enable end cisco2821#
- Как разобрать vlan-tunnel на router, sh_, 17:12 , 03-Май-06 (9)
- Как разобрать vlan-tunnel на router, Boogyman, 17:36 , 03-Май-06 (10)
>conf t >no interface GigabitEthernet0/1.2 >interface GigabitEthernet0/1.2 >enc d 520 ? сенькью!!!! cisco2821(config)#no int gi cisco2821(config)#no int gigabitEthernet 0/1.2 Not all config may be removed and may reappear after reactivating the sub-interface cisco2821(config)#int gi cisco2821(config)#int gigabitEthernet 0/1.2 cisco2821(config-subif)#enc cisco2821(config-subif)#encapsulation d cisco2821(config-subif)#encapsulation dot1Q 520 ? native Make this as native vlan second-dot1q Configure this subinterface as a 1Q-in-1Q subinterface <cr> cisco2821(config-subif)#encapsulation dot1Q 520 sec cisco2821(config-subif)#encapsulation dot1Q 520 second-dot1q ? WORD Second (inner) VLAN IDs e.g. 100,200-300,400,500-600 any All Inner VLAN IDs not configured on another subinterface cisco2821(config-subif)#encapsulation dot1Q 520 second-dot1q 120 ? <cr> cisco2821(config-subif)#encapsulation dot1Q 520 second-dot1q 120 cisco2821(config-subif)#
|