>>>Здравствуйте, давно не рвботал с cisco CLI забыл напроч все. Дело такое,
>>>провайдер дает два интерфейса это static ip типа 192.168.x.x который прописывается
>>>на WAN интерфейсе для подключения к его внутренним ресурсам и PPPoE
>>>поверх того же WAN-а для подключения к интернету, собсно с помощью
>>>SDM первое настроил а вот как прописать PPPoE интерфейс не знаю
>>>:(
>
>если у тебя эзернет, то поменяй ATM на эзернет. Не подскажите где его менять?
Вот мой конфиг
!
version 12.4
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname yourname
!
boot-start-marker
boot-end-marker
!
logging buffered 52000 debugging
!
aaa new-model
!
!
aaa authentication login default local
aaa authorization exec default local
!
aaa session-id common
!
resource policy
!
ip subnet-zero
ip cef
!
!
no ip domain lookup
ip domain name yourdomain.com
!
!
!
interface FastEthernet0
!
interface FastEthernet1
!
interface FastEthernet2
!
interface FastEthernet3
!
interface FastEthernet4
description $ETH-WAN$
ip address 192.168.28.129 255.255.255.0
ip nat outside
ip virtual-reassembly
duplex auto
speed auto
!
interface Vlan1
description $ETH-SW-LAUNCH$$INTF-INFO-HWIC 4ESW$
ip address 192.168.1.2 255.255.255.0
ip nat inside
ip virtual-reassembly
ip tcp adjust-mss 1452
!
ip classless
ip route 0.0.0.0 0.0.0.0 192.168.28.1
!
ip http server
ip http authentication local
ip http secure-server
ip http timeout-policy idle 60 life 86400 requests 10000
ip nat inside source list sun interface FastEthernet4 overload
!
ip access-list extended sun
remark www
remark SDM_ACL Category=2
remark q
permit ip any any
!
access-list 1 remark INSIDE_IF=Vlan1
access-list 1 remark SDM_ACL Category=2
access-list 1 permit 10.10.10.0 0.0.0.7
no cdp run
!
control-plane
!
banner login ^C
-----------------------------------------------------------------------
Cisco Router and Security Device Manager (SDM) is installed on this device.
This feature requires the one-time use of the username "cisco"
with the password "cisco". The default username and password have a privilege level of 15.
Please change these publicly known initial credentials using SDM or the IOS CLI.
Here are the Cisco IOS commands.
username <myuser> privilege 15 secret 0 <mypassword>
no username cisco
Replace <myuser> and <mypassword> with the username and password you want to use.
For more information about SDM please follow the instructions in the QUICK START
GUIDE for your router or go to http://www.cisco.com/go/sdm
-----------------------------------------------------------------------
^C
!
line con 0
no modem enable
line aux 0
line vty 0 4
transport input telnet ssh
!
scheduler max-task-time 5000
end
