The OpenNET Project / Index page

[ новости/++ | форум | wiki | теги | ]

Интерактивная система просмотра системных руководств (man-ов)

 ТемаНаборКатегория 
 
 [Cписок руководств | Печать]

ex (4)
  • ex (1) ( Solaris man: Команды и прикладные программы пользовательского уровня )
  • ex (1) ( FreeBSD man: Команды и прикладные программы пользовательского уровня )
  • ex (1) ( Русские man: Команды и прикладные программы пользовательского уровня )
  • ex (1) ( Linux man: Команды и прикладные программы пользовательского уровня )
  • ex (1) ( POSIX man: Команды и прикладные программы пользовательского уровня )
  • >> ex (4) ( FreeBSD man: Специальные файлы /dev/* )

  • BSD mandoc
     

    NAME

    
    
    ex
    
     - Ethernet device driver for the Intel EtherExpress Pro/10 and Pro/10+
    
     
    

    SYNOPSIS

    To compile this driver into the kernel, place the following line in your kernel configuration file:
    device ex

    Alternatively, to load the driver as a module at boot time, place the following line in loader.conf5:

    if_ex_load="YES"
    
     

    DESCRIPTION

    The driver provides support for Ethernet adapters based on the Intel i82595 chip.

    On the ISA bus, the card will be searched for in the I/O address range 0x200 - 0x3a0. The IRQ will be read from the EEPROM on the card. For correct operation Plug-N-Play support should be disabled.

    On the PC Card bus, the card will be automatically recognized and configured.  

    HARDWARE

    The driver supports the following Ethernet adapters:

     

    DIAGNOSTICS

    "ex%d: Intel EtherExpress Pro/10, address %6D, connector %s"
    The device probe found an installed card, and was able to correctly install the device driver.
    "ex%d: WARNING: board's EEPROM is configured for IRQ %d, using %d"
    The device probe detected that the board is configured for a different interrupt than the one specified in the kernel configuration file.
    "ex%d: invalid IRQ."
    The device probe detected an invalid IRQ setting.

     

    SEE ALSO

    arp(4), netintro(4), ng_ether4, ifconfig(8)  

    HISTORY

    The device driver first appeared in Fx 2.2 .  

    AUTHORS

    An -nosplit The device driver was written by An Javier Mart'in Rueda . The PC Card attachment was written by An Mitsuru ISAWAKI and An Warner Losh . This manual page was written by An David E. O'Brien .  

    BUGS

    Currently the driver does not support multicast.

    The Silicom EtherSerial card's serial port does not currently work. The Olicom OC2232 PC Card should work with the driver, but is currently completely broken.


     

    Index

    NAME
    SYNOPSIS
    DESCRIPTION
    HARDWARE
    DIAGNOSTICS
    SEE ALSO
    HISTORY
    AUTHORS
    BUGS


    Поиск по тексту MAN-ов: 



      Закладки на сайте
      Проследить за страницей
    Created 1996-2017 by Maxim Chirkov  
    ДобавитьРекламаВебмастеруГИД  
    Hosting by Ihor