The OpenNET Project / Index page

[ новости /+++ | форум | wiki | теги | ]

Интерактивная система просмотра системных руководств (man-ов)

 [Cписок руководств | Печать]

rsh (1)
  • rsh (1) ( Solaris man: Команды и прикладные программы пользовательского уровня )
  • >> rsh (1) ( FreeBSD man: Команды и прикладные программы пользовательского уровня )
  • rsh (1) ( Русские man: Команды и прикладные программы пользовательского уровня )
  • rsh (1) ( Linux man: Команды и прикладные программы пользовательского уровня )

  • BSD mandoc


     - remote shell


    [-46dn ] [-l username ] [-t timeout ] host [command]  


    The utility executes command on host

    The utility copies its standard input to the remote command, the standard output of the remote command to its standard output, and the standard error of the remote command to its standard error. Interrupt, quit and terminate signals are propagated to the remote command; normally terminates when the remote command does. The options are as follows:

    Use IPv4 addresses only.
    Use IPv6 addresses only.
    Turn on socket debugging (using setsockopt(2)) on the TCP sockets used for communication with the remote host.
    -l username
    Allow the remote username to be specified. By default, the remote username is the same as the local username. Authorization is determined as in rlogin(1).
    Redirect input from the special device /dev/null (see the Sx BUGS section of this manual page).
    -t timeout
    Allow a timeout to be specified (in seconds). If no data is sent or received in this time, will exit.

    If no command is specified, you will be logged in on the remote host using rlogin(1).

    Shell metacharacters which are not quoted are interpreted on local machine, while quoted metacharacters are interpreted on the remote machine. For example, the command

    rsh otherhost cat remotefile >> localfile

    appends the remote file remotefile to the local file localfile while

    rsh otherhost cat remotefile ">>" other_remotefile

    appends remotefile to other_remotefile  





    rlogin(1), setsockopt(2), rcmd(3), ruserok(3), auth.conf5, hosts(5), hosts.equiv5, rlogind(8), rshd(8)  


    The command appeared in BSD 4.2  


    If you are using csh(1) and put a in the background without redirecting its input away from the terminal, it will block even if no reads are posted by the remote command. If no input is desired you should redirect the input of to /dev/null using the -n option.

    You cannot run an interactive command (like ee(1) or vi(1)) using ; use rlogin(1) instead.

    Stop signals stop the local process only; this is arguably wrong, but currently hard to fix for reasons too complicated to explain here.




    Поиск по тексту MAN-ов: 

    Inferno Solutions
    Hosting by

    Закладки на сайте
    Проследить за страницей
    Created 1996-2020 by Maxim Chirkov
    Добавить, Поддержать, Вебмастеру