firewire - IEEE1394 High-performance Serial Bus
Alternatively, to load the driver as a module at boot time, place the following line in loader.conf5:
The driver consists of two layers: the controller and the bus layer. The controller attaches to a physical bus (like pci(4)). The bus attaches to the controller. Additional drivers can be attached to the bus.
Up to 63 devices, including the host itself, can be attached to a bus. The root node is dynamically assigned with a PHY device function. Also, the other bus specific parameters, e.g., node ID, cycle master, isochronous resource manager and bus manager, are dynamically assigned, after bus reset is initiated. On the bus, every device is identified by an EUI 64 address.
Закладки на сайте
Проследить за страницей
Created 1996-2023 by Maxim Chirkov
Добавить, Поддержать, Вебмастеру