The OpenNET Project / Index page

[ новости /+++ | форум | wiki | теги | ]

Интерактивная система просмотра системных руководств (man-ов)

 ТемаНаборКатегория 
 
 [Cписок руководств | Печать]

uhid (4)
  • >> uhid (4) ( FreeBSD man: Специальные файлы /dev/* )

  • BSD mandoc
     

    NAME

    
    
    uhid
    
     - USB generic HID support
    
     
    

    SYNOPSIS

    To compile this driver into the kernel, place the following line in your kernel configuration file:
    device uhid

    Alternatively, to load the driver as a module at boot time, place the following line in loader.conf5:

    uhid_load="YES"
    
     

    DESCRIPTION

    The driver provides support for all HID (Human Interface Device) interfaces in USB devices that do not have a special driver.

    The device handles the following ioctl(2) calls:

    USB_GET_REPORT_ID (Vt int )
    Get the report identifier used by this HID report.
    USB_GET_REPORT_DESC (Vt struct usb_ctl_report_desc )
    Get the HID report descriptor. Using this descriptor the exact layout and meaning of data to/from the device can be found. The report descriptor is delivered without any processing.
    struct usb_ctl_report_desc {
        int     ucrd_size;
        u_char  ucrd_data[1024];    /* filled data size will vary */
    };
    
    USB_SET_IMMED (Vt int )
    Sets the device in a mode where each read(2) will return the current value of the input report. Normally a read(2) will only return the data that the device reports on its interrupt pipe. This call may fail if the device does not support this feature.
    USB_GET_REPORT (Vt struct usb_ctl_report )
    Get a report from the device without waiting for data on the interrupt pipe. The report field indicates which report is requested. It should be UHID_INPUT_REPORT UHID_OUTPUT_REPORT or UHID_FEATURE_REPORT This call may fail if the device does not support this feature.
    struct usb_ctl_report {
            int ucr_report;
            u_char  ucr_data[1024]; /* used data size will vary */
    };
    
    USB_SET_REPORT (Vt struct usb_ctl_report )
    Set a report in the device. The report field indicates which report is to be set. It should be UHID_INPUT_REPORT UHID_OUTPUT_REPORT or UHID_FEATURE_REPORT This call may fail if the device does not support this feature.

    Use read(2) to get data from the device. Data should be read in chunks of the size prescribed by the report descriptor.

    Use write(2) to send data to the device. Data should be written in chunks of the size prescribed by the report descriptor.  

    FILES

    /dev/uhid?

     

    SEE ALSO

    usbhidctl(1), usb(4)  

    HISTORY

    The driver appeared in Nx 1.4 . This manual page was adopted from Nx by An Tom Rhodes Aq trhodes@FreeBSD.org in April 2002.


     

    Index

    NAME
    SYNOPSIS
    DESCRIPTION
    FILES
    SEE ALSO
    HISTORY


    Поиск по тексту MAN-ов: 




    Спонсоры:
    PostgresPro
    Inferno Solutions
    Hosting by Hoster.ru
    Хостинг:

    Закладки на сайте
    Проследить за страницей
    Created 1996-2022 by Maxim Chirkov
    Добавить, Поддержать, Вебмастеру