The OpenNET Project / Index page

[ новости /+++ | форум | wiki | теги | ]

Интерактивная система просмотра системных руководств (man-ов)

 ТемаНаборКатегория 
 
 [Cписок руководств | Печать]

aue (4)
  • >> aue (4) ( FreeBSD man: Специальные файлы /dev/* )

  • BSD mandoc
     

    NAME

    
    
    aue
    
     - ADMtek AN986 Pegasus USB Ethernet driver
    
     
    

    SYNOPSIS

    To compile this driver into the kernel, place the following lines in your kernel configuration file:
    device uhci device ohci device usb device miibus device aue

    Alternatively, to load the driver as a module at boot time, place the following line in loader.conf5:

    if_aue_load="YES"
    
     

    DESCRIPTION

    The driver provides support for USB Ethernet adapters based on the ADMtek AN986 Pegasus chipset.

    The LinkSys USB10T adapters that contain the AN986 Pegasus chipset will operate at 100Base-TX and full-duplex.

    The Pegasus contains a 10/100 Ethernet MAC with MII interface and is designed to work with both Ethernet and HomePNA transceivers. Although designed to interface with 100Mbps peripherals, the existing USB standard specifies a maximum transfer speed of 12Mbps. Users should therefore not expect to actually achieve 100Mbps speeds with these devices.

    The Pegasus supports a 64-bit multicast hash table, single perfect filter entry for the station address and promiscuous mode. Packets are received and transmitted over separate USB bulk transfer endpoints.

    The driver supports the following media types:

    autoselect
    Enable autoselection of the media type and options. The user can manually override the autoselected mode by adding media options to the /etc/rc.conf file.
    10baseT/UTP
    Set 10Mbps operation. The mediaopt option can also be used to enable full-duplex operation. Not specifying full duplex implies half-duplex mode.
    100baseTX
    Set 100Mbps (Fast Ethernet) operation. The mediaopt option can also be used to enable full-duplex operation. Not specifying full duplex implies half-duplex mode.

    The driver supports the following media options:

    full-duplex
    Force full duplex operation. The interface will operate in half duplex mode if this media option is not specified.

    For more information on configuring this device, see ifconfig(8).  

    HARDWARE

    Adapters supported by the driver include:

     

    DIAGNOSTICS

    "aue%d: watchdog timeout"
    A packet was queued for transmission and a transmit command was issued, however the device failed to acknowledge the transmission before a timeout expired.
    "aue%d: no memory for rx list"
    The driver failed to allocate an mbuf for the receiver ring.

     

    SEE ALSO

    altq(4), arp(4), miibus(4), netintro(4), ng_ether4, ifconfig(8)
    ADMtek AN986 data sheet http://www.admtek.com.tw
     

    HISTORY

    The device driver first appeared in Fx 4.0 .  

    AUTHORS

    The driver was written by An Bill Paul Aq wpaul@ee.columbia.edu .


     

    Index

    NAME
    SYNOPSIS
    DESCRIPTION
    HARDWARE
    DIAGNOSTICS
    SEE ALSO
    HISTORY
    AUTHORS


    Поиск по тексту MAN-ов: 




    Спонсоры:
    PostgresPro
    Inferno Solutions
    Hosting by Hoster.ru
    Хостинг:

    Закладки на сайте
    Проследить за страницей
    Created 1996-2022 by Maxim Chirkov
    Добавить, Поддержать, Вебмастеру