>Там все скази, нету иде...
А если после старта примотировать дискету и установит драйвер? Я для мадрейка прочитал как драйвера ставятся, там такой принцып.
.2 To install the FastTrak Series Linux Driver into a NEW SYSTEM
1.) Start the Mandrake Linux installation with CD-ROM booting.
2.) At the Mandrake Linux installation screen appear, Press F1.
3.) Append parameters (see Note 1 below) at the "boot:" prompt,
then press the Enter key.
4.) When "If you want to insert third-party kernel modules?"
message appear, Please select "No" to continue install.
5.) Press Ctrl-Alt-F2 at language selection menu, insert the
FastTrak Driver Disk in the floppy drive.
6.) Issue following commands to load FastTrak module, Because
Mandrake linux not initial floppy device at startup.
# modprobe floppy
# mkdir /floppy
# mount -t ext2 /dev/fd0 /floppy (Extract from linux)
or mount -t vfat /dev/fd0 /floppy (Extract from Windows)
# cd /floppy
# sh floppy.fix
# cd /
# umount /floppy
7.) Then Press Ctrl-Alt-F7 and proceed with the install.
8.) When installation at "Install bootloader" menu, click "Advanced"
button then click "OK" button. If you have multi-boot items, please
select each ertries then click "Modify" button, append kernel
parameters at Append field.
(see NOTE 2 below)
9.) Push "OK" button then push "Done" botton. Continue to proceed with
the install.
10.) Press Ctrl-Alt-F2 when installation at the Final step(Congratulations,
installation is complete)
11.) Insert the FastTrak Driver Disk floppy, Issue commands to load FastTrak
driver.
# chroot /mnt/
# mount /dev/fd0 /mnt/floppy
# cd /mnt/floppy
# sh setup-ft
12.) Choose your selection here, after FastTrak driver setup successful.
# cd /
# umount /mnt/floppy
# exit
13.) Please press Ctrl-Alt-F7 and push "OK" button to finish the installation.
Вариант для распечатки
OpenNET: Виртуальная конференция (Public)
on
30-Июл-03, 12:58 (MSK)
