Интерактивная система просмотра системных руководств (man-ов)
>> snd_atiixp (4) ( FreeBSD man: Специальные файлы /dev/* )
- ATI IXP bridge device driver
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
Alternatively, to load the driver as a module at boot time, place the
following line in
bridge driver allows the generic audio driver,
to attach to ATI IXP audio devices.
This driver supports 16bit playback and recording, and 32bit native playback
variables are available in addition to those available to all
Experimental polling mode, where the driver operates by querying the device
state on each tick using
Polling is disabled by default.
Do not enable it unless you are facing weird interrupt problems or if the
device cannot generate interrupts at all.
driver supports the following audio chipsets:
ATI IXP 200
ATI IXP 300
ATI IXP 400
device driver first appeared in
Fx 6.1 .
This manual page was written by
An Joel Dahl Aq joel@FreeBSD.org
does not support S/PDIF, but implementing it should be fairly easy if the
right hardware is available.
32bit native recording is broken on some hardware.
- Runtime Configuration
- SEE ALSO