The OpenNET Project / Index page

[ новости /+++ | форум | wiki | теги | ]

Интерактивная система просмотра системных руководств (man-ов)

 ТемаНаборКатегория 
 
 [Cписок руководств | Печать]

quotacheck (8)
  • quotacheck (1) ( Solaris man: Команды и прикладные программы пользовательского уровня )
  • >> quotacheck (8) ( FreeBSD man: Команды системного администрирования )
  • quotacheck (8) ( Linux man: Команды системного администрирования )

  • BSD mandoc
     

    NAME

    
    
    quotacheck
    
     - file system quota consistency checker
    
     
    

    SYNOPSIS

    [-guv ] [-l maxrun ] -a
    [-guv ] filesystem ...  

    DESCRIPTION

    The utility examines each file system, builds a table of current disk usage, and compares this table against that recorded in the disk quota file for the file system. If any inconsistencies are detected, both the quota file and the current system copy of the incorrect quotas are updated (the latter only occurs if an active file system is checked). By default both user and group quotas are checked.

    The following options are available:

    -a
    If supplied in place of any file system names, will check all the file systems indicated in /etc/fstab to be read-write with disk quotas. By default only the types of quotas listed in /etc/fstab are checked.
    -g
    Only group quotas listed in /etc/fstab are to be checked.
    -l maxrun
    Specifies the maximum number of concurrent file systems to check in parallel. If this option is omitted, or if maxrun is zero, parallel passes are run as per fsck(8).
    -u
    Only user quotas listed in /etc/fstab are to be checked.
    -v
    Report discrepancies between the calculated and recorded disk quotas and other additional diagnostic messages.

    Specifying both -g and -u is equivalent to the default. Parallel passes are run on the file systems required, using the pass numbers in /etc/fstab in an identical fashion to fsck(8).

    Normally, operates silently.

    The utility expects each file system to be checked to have a quota files named quota.user and quota.group which are located at the root of the associated file system. These defaults may be overridden in /etc/fstab If a file is not present, will create it. These files should be edited with the edquota(8) utility.

    The utility is normally run at boot time from the /etc/rc file. The rc startup procedure is controlled by the /etc/rc.conf variable check_quotas Note that to enable this functionality in /etc/rc you also need to enable startup quota procedures with the variable enable_quotas in /etc/rc.conf The kernel must also be built with options QUOTA

    The utility accesses the raw device in calculating the actual disk usage for each user. Thus, the file systems checked should be quiescent while is running.  

    FILES

    quota.user
    at the file system root with user quotas
    quota.group
    at the file system root with group quotas
    /etc/fstab
    default file systems

     

    SEE ALSO

    quota(1), quotactl(2), fstab(5), rc.conf5, edquota(8), fsck(8), quotaon(8), repquota(8)  

    HISTORY

    The utility appeared in BSD 4.2  

    BUGS

    The quota system will ignore UIDs or GIDs that would be negative when evaluated as a signed value. Typically those types of ids can appear in the file system from NFS mounts or archive files from other operating systems. Extremely large UIDs or GIDs will cause to run for an unreasonable amount of time and also produce extremely large quota data files.


     

    Index

    NAME
    SYNOPSIS
    DESCRIPTION
    FILES
    SEE ALSO
    HISTORY
    BUGS


    Поиск по тексту MAN-ов: 




    Спонсоры:
    Inferno Solutions
    Hosting by Hoster.ru
    Хостинг:

    Закладки на сайте
    Проследить за страницей
    Created 1996-2021 by Maxim Chirkov
    Добавить, Поддержать, Вебмастеру