nanosleep - high resolution sleep (REALTIME)
int nanosleep(const struct timespec *rqtp, struct timespec
The nanosleep() function shall cause the current thread to be suspended from execution until either the time interval specified by the rqtp argument has elapsed or a signal is delivered to the calling thread, and its action is to invoke a signal-catching function or to terminate the process. The suspension time may be longer than requested because the argument value is rounded up to an integer multiple of the sleep resolution or because of the scheduling of other activity by the system. But, except for the case of being interrupted by a signal, the suspension time shall not be less than the time specified by rqtp, as measured by the system clock CLOCK_REALTIME.
The use of the nanosleep() function has no effect on the action or blockage of any signal.
If the nanosleep() function returns because the requested time has elapsed, its return value shall be zero.
If the nanosleep() function returns because it has been interrupted by a signal, it shall return a value of -1 and set errno to indicate the interruption. If the rmtp argument is non-NULL, the timespec structure referenced by it is updated to contain the amount of time remaining in the interval (the requested time minus the time actually slept). If the rmtp argument is NULL, the remaining time is not returned.
If nanosleep() fails, it shall return a value of -1 and set errno to indicate the error.
The nanosleep() function shall fail if:
The following sections are informative.
It is common to suspend execution of a process for an interval in order to poll the status of a non-interrupting function. A large number of actual needs can be met with a simple extension to sleep() that provides finer resolution.
In the POSIX.1-1990 standard and SVR4, it is possible to implement such a routine, but the frequency of wakeup is limited by the resolution of the alarm() and sleep() functions. In 4.3 BSD, it is possible to write such a routine using no static storage and reserving no system facilities. Although it is possible to write a function with similar functionality to sleep() using the remainder of the timer_*() functions, such a function requires the use of signals and the reservation of some signal number. This volume of IEEE Std 1003.1-2001 requires that nanosleep() be non-intrusive of the signals function.
The nanosleep() function shall return a value of 0 on success and -1 on failure or if interrupted. This latter case is different from sleep(). This was done because the remaining time is returned via an argument structure pointer, rmtp, instead of as the return value.
sleep() , the Base Definitions volume of IEEE Std 1003.1-2001, <time.h>
Закладки на сайте
Проследить за страницей
Created 1996-2023 by Maxim Chirkov
Добавить, Поддержать, Вебмастеру