The OpenNET Project / Index page

[ новости/++ | форум | wiki | теги | ]

Интерактивная система просмотра системных руководств (man-ов)

 ТемаНаборКатегория 
 
 [Cписок руководств | Печать]

if_de (4)
  • >> if_de (4) ( FreeBSD man: Специальные файлы /dev/* )

  • BSD mandoc
     

    NAME

    
    
    de
    
     - DEC DC21x4x Ethernet device driver
    
     
    

    SYNOPSIS

    To compile this driver into the kernel, place the following line in your kernel configuration file:
    device de

    Alternatively, to load the driver as a module at boot time, place the following line in loader.conf5:

    if_de_load="YES"
    
     

    DESCRIPTION

    The driver provides support for the Ethernet adapters based on the Digital Equipment DC21x4x based self-contained Ethernet and Fast Ethernet chips.

    The driver supports the following media types:

    autoselect
    Enable autoselection of the media type and options
    10baseT/UTP
    Set 10Mbps operation on the 10baseT port
    10base2/BNC
    Set 10Mbps operation on the BNC port
    10base5/AUI
    Set 10Mbps operation on the AUI port
    100baseTX
    Set 100Mbps (Fast Ethernet) operation
    100baseFX
    Set 100Mbps operation
    100baseT4
    Set 100Mbps operation (4-pair cat-3 cable)

    The driver supports the following media options:

    full-duplex
    Set full duplex operation

    Note that the media types available depend on the particular card in use. Some cards are explicitly programmed to a particular media type by a setup utility and are not changeable.

    Use the ifconfig(8) command an in particular the -m flag to list the supported media types for your particular card.

    The old ``ifconfig linkN'' method of configuration is not supported.  

    HARDWARE

    Adapters supported by the driver include:

     

    DIAGNOSTICS

    "de%d: waking device from sleep/snooze mode"
    The 21041 and 21140A chips support suspending the operation of the card.
    "de%d: error: desired IRQ of %d does not match device's actual IRQ of %d"
    The device probe detected that the board is configured for a different interrupt than the one specified in the kernel configuration file.
    "de%d: not configured; limit of %d reached or exceeded"
    There is a limit of 32 devices allowed in a single machine.
    "de%d: not configured; 21040 pass 2.0 required (%d.%d found)"
    "de%d: not configured; 21140 pass 1.1 required (%d.%d found)"
    Certain revisions of the chipset are not supported by this driver.

     

    SEE ALSO

    altq(4), arp(4), netintro(4), ng_ether4, ifconfig(8)  

    AUTHORS

    An -nosplit The device driver was written by An Matt Thomas . This manual page was written by An David E. O'Brien .


     

    Index

    NAME
    SYNOPSIS
    DESCRIPTION
    HARDWARE
    DIAGNOSTICS
    SEE ALSO
    AUTHORS


    Поиск по тексту MAN-ов: 



      Закладки на сайте
      Проследить за страницей
    Created 1996-2017 by Maxim Chirkov  
    ДобавитьРекламаВебмастеруГИД  
    Hosting by Ihor