Интерактивная система просмотра системных руководств (man-ов)
>> ghpftodit (1) ( Linux man: Команды и прикладные программы пользовательского уровня )
hpftodit - create font description files for use with groff -Tlj4
It is possible to have whitespace between the
command line option and its parameter.
creates a font file for use with
from an HP tagged font metric file.
is the name of the tagged font metric file for the font.
is a file giving the groff names for characters in the font;
this file should consist of a sequence of lines of the form:
n c1 c2 ...
is a decimal integer giving the MSL number of the character,
are the groff names of the character.
is the name of the groff font file.
The groff font file is written to
option should be given if the font is special
(a font is
should search it whenever
a character is not found in the current font.)
If the font is special,
it should be listed in the
command in the DESC file;
if it is not special, there is no need to list it, since
can automatically mount it when it's first used.
option is used,
will automatically generate an italic correction,
a left italic correction and a subscript correction
for each character
(the significance of these parameters is explained in
Print the version number.
The font is special.
The effect of this option is to add the
command to the font file.
Generate an italic correction for each character so that
the character's width plus the character's italic correction
is equal to
plus the amount by which the right edge of the character's bounding
is to the right of the character's origin.
If this would result in a negative italic correction, use a zero
italic correction instead.
There are 8782 design units per em for Intellifont fonts.
Also generate a subscript correction equal to the
product of the tangent of the slant of the font and
four fifths of the x-height of the font.
If this would result in a subscript correction greater than the italic
correction, use a subscript correction equal to the italic correction
Also generate a left italic correction for each character
plus the amount by which the left edge of the character's bounding box
is to the left of the character's origin.
The left italic correction may be negative.
This option is normally needed only with italic (or oblique) fonts.
Device description file.
Font description file for font
This program was written without the benefit of complete, official
documentation on the tagged font metric format.
It is therefore likely that it will fail to work on tfm files that are
dissimilar to those for the internal fonts on the Laserjet 4,
with which it was tested:
TrueType tfm files are not supported.
- SEE ALSO