The OpenNET Project / Index page

[ новости /+++ | форум | wiki | теги | ]

Интерактивная система просмотра системных руководств (man-ов)

 ТемаНаборКатегория 
 
 [Cписок руководств | Печать]

dpt (7)
  • dpt (4) ( FreeBSD man: Специальные файлы /dev/* )
  • >> dpt (7) ( Solaris man: Макропакеты и соглашения )
  •  

    NAME

    dpt - DPT ServeRAID IV SCSI host bus
    adapter and RAID adapter driver
     
    

    DESCRIPTION

    The dpt driver is a driver for the DPT (Distributed Processing Technology) family of SmartRAID IV SCSI HBA and RAID adapters. The following HBA adapters are supported: PM2024, PM2044UW, PM2044W, PM2124, PM2124W, PM2144UW, and PM2144W.

    The following RAID adapters are supported: PM3224, PM3224W, PM3334UW, and PM3334W.  

    PRECONFIGURATION

    o DPT PM3224 only: Only EPROM 7A and later versions are supported.
    o DPT PM2024 and PM2124 only: Only EPROM 6D4 and later versions are supported.
    o Use adapters with SmartROM version 3.B or later versions only.
    o Be sure that the controller board is installed in a PCI bus-mastering slot.
    o Disable PCI parity checking if your firmware version is earlier than version 7A, if your system memory is ECC, or if your system does not check parity.
     

    Known Problems and Limitations

    During system boot, a message may be displayed saying a DPT controller driver cannot be installed. This message indicates that the motherboard installed in your system may contain ECC memory or may not check parity. If you see this message is displayed, disable PCI parity checking.  

    Supported Settings

    o I/O Address: Auto
     

    CONFIGURATION

    Auto-configuration code determines whether the adapter is present at the configured address and what types of devices are attached to it. The DPT ServeRAID is primarily used as a disk array (system drive) controller.

    To configure the attached disk arrays, you must configure the controller (using the configuration utilities provided by the hardware manufacturer) before you boot the Solaris operating environment. You use the configuration utilities to set RAID levels, stripe parameters, cache mechanisms and perform other functions. For more information, see the user manual supplied with your hardware.  

    FILES

    /kernel/drv/dpt.conf

    dpt configuration file

    /dev/dsk/cndn[s|p]n

    block device

    /dev/rdsk/cndn[s|p]n

    raw device where:

    cn

    controller n

    dn

    LUN n (0-7)

    sn

    UNIX system slice n (0-15)

    pn

    fdisk(1M) partition (0)

     

    ATTRIBUTES

    See attributes(5) for descriptions of the following attributes:

    ATTRIBUTE TYPEATTRIBUTE VALUE
    Architecturex86

     

    SEE ALSO

    fdisk(1M), attributes(5), cmdk(7D)


     

    Index

    NAME
    DESCRIPTION
    PRECONFIGURATION
    Known Problems and Limitations
    Supported Settings
    CONFIGURATION
    FILES
    ATTRIBUTES
    SEE ALSO


    Поиск по тексту MAN-ов: 




    Партнёры:
    PostgresPro
    Inferno Solutions
    Hosting by Hoster.ru
    Хостинг:

    Закладки на сайте
    Проследить за страницей
    Created 1996-2024 by Maxim Chirkov
    Добавить, Поддержать, Вебмастеру