runx - try to overcome problems of Xfree96 restoring textmode using svgalib.
The runx script actually is:
Note that this doesn't help with syncing problems.
A more rigorous alternative is to run the savetextmode(1) script before running X, and textmode(1) after. This will restore the textmode registers and the VGA palette in addition to the VGA font.
Assuming that savetextmode(1) and textmode(1) are in your PATH the runx script would then look like:
This utility is part of svgalib and can be found in the utils/ subdirectory of the original svgalib distribution. However, it is not installed by default, s.t. it is unclear where you can find it if your svgalib was install by a linux distribution.
However, this is no big deal as it was printed out above already ;-).
svgalib(7), vgagl(7), libvga.config(5), convfont(1), dumpreg(1), restorefont(1), restorepalette(1), restoretextmode(1), fix132x43(1), savetextmode(1), setmclk(1), textmode(1).
This manual page was edited by Michael Weller <firstname.lastname@example.org>. The exact source of the referenced utility as well as of the original documentation is unknown.
It is very likely that both are at least to some extent are due to Harm Hanemaayer <H.Hanemaayer@inter.nl.net>.
Occasionally this might be wrong. I hereby asked to be excused by the original author and will happily accept any additions or corrections to this first version of the svgalib manual.
Закладки на сайте
Проследить за страницей
Created 1996-2023 by Maxim Chirkov
Добавить, Поддержать, Вебмастеру