Исходное сообщение
"Serial0/3 is up, line protocol is down" Отправлено loewa, 21-Сен-05 06:55
>cisco 2650 >Неподнимается связь >interface Serial0/3 > ip unnumbered Loopback0 > ip mask-reply > encapsulation ppp > ntp disable > no fair-queue >Если втавить этот модуль в cisco3660 то всё сразу заводится настройки обсолютно >одинаковые >В чём может быть проблема ??? >2650 - Version 12.2(29) >3360 - Version 12.0(7)XK2 Serial0/3 is up, line protocol is down   Hardware is PowerQUICC Serial   Description: To_SB   Interface is unnumbered. Using address of Loopback0 (172.26.255.144)   MTU 1500 bytes, BW 2048 Kbit, DLY 20000 usec,      reliability 237/255, txload 1/255, rxload 1/255   Encapsulation PPP, loopback not set   Keepalive set (10 sec)   LCP Listen   Closed: IPCP, CDPCP   Last input 00:00:00, output 00:00:00, output hang never   Last clearing of "show interface" counters 09:35:23   Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0   Queueing strategy: fifo   Output queue: 0/40 (size/max)   5 minute input rate 0 bits/sec, 1 packets/sec   5 minute output rate 0 bits/sec, 0 packets/sec      57099 packets input, 662350 bytes, 0 no buffer      Received 0 broadcasts, 0 runts, 0 giants, 0 throttles      7118 input errors, 0 CRC, 7118 frame, 0 overrun, 0 ignored, 0 abort      38821 packets output, 475010 bytes, 0 underruns      0 output errors, 0 collisions, 12566 interface resets      0 output buffer failures, 0 output buffers swapped out      0 carrier transitions      DCD=up  DSR=up  DTR=up  RTS=up  CTS=up