Спасибо еще раз, KostyaK, за версию ;)но не помогло
1. версия IOS
sh ver | i 1841
Cisco IOS Software, 1841 Software (C1841-ADVENTERPRISEK9-M), Version 12.4(5a), RELEASE SOFTWARE (fc3)
System image file is "flash:c1841-adventerprisek9-mz.124-5a.bin"
Cisco 1841 (revision 7.0) with 117760K/13312K bytes of memory.
2. порт ADSL отсутствует
sh dsl int atm0/0/0
^
% Invalid input detected at '^' marker.
sh ip int brief
Interface IP-Address OK? Method Status Protocol
FastEthernet0/0 172.16.2.189 YES NVRAM up up
FastEthernet0/1 unassigned YES NVRAM administratively down down
Dialer1 unassigned YES NVRAM up up
3. IPSec на месте
#crypto ?
ca Certification authority
call Configure Crypto Call Admission Control
dynamic-map Specify a dynamic crypto map template
engine Enter a crypto engine configurable menu
identity Enter a crypto identity list
ipsec Configure IPSEC policy
isakmp Configure ISAKMP policy
..........
...........
4.
sh ver
Cisco IOS Software, 1841 Software (C1841-ADVENTERPRISEK9-M), Version 12.4(5a), RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by Cisco Systems, Inc.
Compiled Fri 13-Jan-06 15:21 by alnguyen
ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
ххххххххххххххх
Cisco 1841 (revision 7.0) with 117760K/13312K bytes of memory.
Processor board ID FCZ1135113E
2 FastEthernet interfaces
1 Virtual Private Network (VPN) Module
DRAM configuration is 64 bits wide with parity disabled.
191K bytes of NVRAM.
62976K bytes of ATA CompactFlash (Read/Write)
Configuration register is 0x2102
беда-огорчение :(