Ещё из новшеств 1.1.0: появилась поддержка VRF.router(config)#
access-list Add an access list entry
bgp BGP information
debug Debugging functions (see also 'undebug')
default Configure defaults of settings
dump Dump packet
enable Modify enable password parameters
end End current mode and change to enable mode
exit Exit current mode and down to previous mode
fpm fpm connection remote ip and port
hostname Set system's network name
interface Select an interface to configure
ip IP information
ipv6 IPv6 information
key Authentication key management
line Configure a terminal line
list Print command list
log Logging control
no Negate a command or set its defaults
password Assign the terminal connection password
route-map Create route-map or enter route-map command mode
router Enable a routing process
router-id Manually set the router-id
service Set up miscellaneous service
show Negate a command or set its defaults
table Configure target kernel routing table
undebug Disable debugging functions (see also 'debug')
username
vrf Enable a VRF
router# show ip route
<cr>
A.B.C.D Network in the IP routing table to display
A.B.C.D/M IP prefix <network>/<length>, e.g., 35.0.0.0/8
babel Babel routing protocol (Babel)
bgp Border Gateway Protocol (BGP)
connected Connected routes (directly attached subnet or host)
isis Intermediate System to Intermediate System (IS-IS)
kernel Kernel routes (not installed via the zebra RIB)
ospf Open Shortest Path First (OSPFv2)
pim Protocol Independent Multicast (PIM)
rip Routing Information Protocol (RIP)
static Statically configured routes
summary Summary of all routes
supernets-only Show supernet entries only
tag Show only routes with tag
vrf Specify the VRF