>>Дело в том, что звонок со станции к которой подключена циска на
>>тот же номер (с обычного проводного телефона) проходит нормально....
>вобщем, учитывая муторность настройки некоторых станций это не паказатель
>подключите к своему потоку еще что-нибудь: небольшую-атс, другую циску и проверьте
>
>>И пока не разделили на 2-х операторов трафик тоже все было нормально....
>как я понимаю при этом на циске никаких переконфигураций небыло, только на
>станции
>
>
>еще можно попробовать bearer-cap 3100hz на voice-port, но маловероятно т.к. speech должен
>проходить voice-port 1:15
cptone RU
timeouts initial 3
timeouts interdigit 3
(config-voiceport)#?
Voice-port configuration commands:
busyout Configure busyout trigger event & procedure
codec Default voice codec
comfort-noise Use fill-silence option
compand-type The companding type for this voice port
condition Condition Signaling bit patterns
connection Specify Trunking Parameters
cptone Configure voice call progress tone locale
default Set a command to its defaults
description Description of what this port is connected to
disc-pi-off close voice path when disconnect with PI received
echo-cancel Echo-cancellation option
exit Exit from voice-port configuration mode
input Configure input gain for voice
music-threshold Threshold for Music on Hold
no Negate a command or set its defaults
non-linear Use non-linear processing during echo cancellation
output Configure output attenuation for voice
playout-delay Configure voice playout delay buffer
shutdown Take voice-port offline
station-id Configure station ID
timeouts Configure voice timeout parameters
translate Translation rule
vad Use VoiceActivityDetection-as-necessary option
voice-class Set voiceport voice class control parameters
Нету такого :(
sh ver
Cisco Internetwork Operating System Software
IOS (tm) MC3810 Software (MC3810-A2ISV5-M), Version 12.2(2)XB15, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled Tue 09-Dec-03 01:25 by cmong
Image text-base: 0x00023000, data-base: 0x01071960
ROM: System Bootstrap, Version 12.0(6r)T4, RELEASE SOFTWARE (fc1)
ROM: MC3810 Software (MC3810-WBOOT-M), Version 12.0(1)XA4, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
qq uptime is 3 weeks, 3 days, 4 hours, 30 minutes
System returned to ROM by power-on
System image file is "flash:mc3810-a2isv5-mz.122-2.XB15.bin"
cisco MC3810 (MPC860) processor (revision 16.00) with 57344K/8192K bytes of memory.
Processor board ID 14761527
PPC860 PowerQUICC, partnum 0x0000, version C01(0x0031)
Channelized E1, Version 1.0.
Bridging software.
X.25 software, Version 3.0.0.
Primary Rate ISDN software, Version 1.1.
MC3810 SCB board (v16.A0)
1 Multiflex E1(slot 4) RJ45 interface(v01.K0)
1 6-DSP(slot2) Voice Compression Module(v01.K0)
1 6-DSP(slot5) Voice Compression Module(v01.K0)
1 Ethernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
2 Serial(sync/async) network interface(s)
1 Channelized E1/PRI port(s)
256K bytes of non-volatile configuration memory.
0K bytes of processor board System flash (AMD29F016)
Configuration register is 0x2102
